How to Install a Silhouette Wall Design

For Valentine's Day I created a wall design to go around gallery of pictures shown in the post "To my Valentine".  Frankly, I was surprised it turned out as good as it did.



The idea started with just putting a saying together.  I used my Silhouette Cameo machine and I wrote out and cut  "the gift of love brings infinite gifts" using a font I found on dafont.com called "I love what you do".

Then I thought what would happen if I made it look like a heart?  The worst that would happen is  I'd just peel it off - right!?.  So off I went. :)



Using painters tape, I placed each piece and shifted them around as needed.  It was at this point that I wasn't sure I was going to like it because it looked pretty busy. But again, what did I stand to lose?



Here is how I did it: After I placed each piece. I made sure it was level and symmetric with the piece across from it.



Then I  flipped the piece up and pulled off the transfer tape's backing.



Using a card (this is what I had handy :) ) I smoothed the Silhouette Design onto the wall.



Then, I grabbed the painters tape and slowly pull off the transfer tape.



And then I was done with that piece.



Once I saw several pieces on the wall, I knew I'd love it!



 I hope this helps inspire you and go buy one of the best tangible gifts I've been given!  The creativity is endless with this machine! I LOVE my Silhouette Cameo!

Stephanie Weaver

Grinning Like An Idiot: Create your Happiness. I'm a stay-at-home mom who doesn't 'stay' very well. I like to provide everyone with resources and ideas for crafts, painting and DIY!